MAIN BODY ECU > REMOVAL |
| 1. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
| 2. REMOVE INSTRUMENT PANEL WIRE |
![]() |
Remove the bolt.
Disengage the 2 clamps and disconnect the instrument panel wire.
| 3. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Disengage the clamp.
Disconnect the connector (A).
Disengage the 2 claws and disconnect the 2 connectors (B).
![]() |
Remove the 2 bolts.
Disengage the 2 clamps and pull out the instrument panel junction block assembly.
![]() |
Disengage the claw and disconnect the connector as shown in the illustration.
![]() |
Disengage the claw and release the connector lock as shown in the illustration.
![]() |
Disengage the claw and disconnect the connector as shown in the illustration to remove the instrument panel junction block assembly.
| 4. REMOVE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
![]() |
Press the claw of the junction block as shown in the illustration to release the lock.
| *1 | Instrument Panel Junction Block |
| *2 | Main Body ECU (Multiplex Network Body ECU) |
![]() |
With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the main body ECU (multiplex network body ECU) and junction block.
| *1 | Protective Tape |
Using the screwdriver, carefully raise the main body ECU (multiplex network body ECU) up to the position where the connector becomes disengaged.
![]() |
Raise the main body ECU (multiplex network body ECU) as shown by the arrow (1), and then pull it out as shown by the arrow (2) in the illustration.