Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY


    E171721E44
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Front Wiper Switch 
    Tester Connection
    Switch Condition
    Specified Condition
    G14-1 (+S) - G14-3 (+1)
    OFF
    Below 1 Ω
    INT
    G14-2 (+B) - G14-3 (+1)
    MIST
    LO
    G14-2 (+B) - G14-4 (+2)
    HI
    Front Washer Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    G12-2 (EW) - G12-3 (WF)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher
    Rear Wiper Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    G12-6 (C1R) - G12-2 (EW)
    OFF
    10 kΩ or higher
    G12-7 (+1R) - G12-2 (EW)
    G12-6 (C1R) - G12-2 (EW)
    INT
    Below 1 Ω
    G12-7 (+1R) - G12-2 (EW)
    HI
    Below 1 Ω
    Rear Washer Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    G14-5 (WR) - G12-2 (EW)
    OFF
    10 kΩ or higher
    G12-7 (+1R) - G12-2 (EW)
    G14-5 (WR) - G12-2 (EW)
    WASH
    Below 1 Ω
    G14-5 (WR) - G12-2 (EW)
    ON + WASH
    Below 1 Ω
    G12-7 (+1R) - G12-2 (EW)

    If the result is not as specified, replace the windshield wiper switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Windshield Wiper Switch Assembly)



  1. Check the intermittent operation.

    1. Connect a voltmeter positive (+) lead to terminal G14-3 (+1) and a negative (-) lead to terminal G12-2 (EW).

    2. Connect an auxiliary battery positive (+) lead to terminal G14-2 (+B) and a negative (-) lead to terminal G12-2 (EW) and G14-1 (+S).

    3. Turn the wiper switch to the INT position.

    4. Connect an auxiliary battery positive (+) lead to terminal G14-1 (+S) for 5 seconds.



    5. Connect an auxiliary battery negative (-) lead to terminal G14-1 (+S). Operate the intermittent wiper relay and check the voltage between terminals G14-3 (+1) and G12-2 (EW).

      OK:
      Voltage changes as shown in the illustration.



      E056399E62

      If the result is not as specified, replace the windshield wiper switch assembly.

      Text in Illustration 
      *a
      Voltage between terminals G14-3 (+1) and G12-2 (EW)
      *b
      FAST: Connect auxiliary battery negative lead to terminal G14-1 (+S)
      *c
      SLOW: Connect auxiliary battery negative lead to terminal G14-1 (+S)
      -
      -