NOISE FILTER > ON-VEHICLE INSPECTION |
| 1. INSPECT RADIO SETTING CONDENSER |
With the radio setting condenser installed, check that there is no looseness or other abnormalities.
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
![]() |
Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 |
| 10 kΩ or higher |
| 3 - Body ground | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| 1 - Body ground |
| Below 1 V |
| 1 - Body ground |
| 11 to 14 V |
| *a | Radio Setting Condenser |