HYBRID TRANSAXLE FLUID > REPLACEMENT |
| 1. REPLACE HYBRID TRANSAXLE FLUID |
Be sure that the vehicle remains level and lift the vehicle. [*1]
![]() |
Using a 10 mm hexagon socket wrench, remove the filler plug and gasket. [*2]
![]() |
Using a 10 mm hexagon socket wrench, remove the drain plug and gasket to drain the hybrid transaxle fluid. [*3]
Using a 10 mm hexagon socket wrench, temporarily install the drain plug and gasket. [*4]
![]() |
Add transaxle fluid until the fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening. [*5]
| *1 | Filler Nozzle |
Using a 10 mm hexagon socket wrench, temporarily install the filler plug and gasket. [*6]
Lower the vehicle. [*7]
Connect the Techstream to the DLC3 and turn the ignition switch to ON (IG). [*8]
Put the engine in inspection mode (Click here). [*9]
Idle the engine for 30 seconds with the ignition switch to ON (READY). [*10]
Turn the ignition switch off. [*11]
Repeat steps [*1] to [*11].
Repeat steps [*1] to [*3].
Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket.
| 2. ADD HYBRID TRANSAXLE FLUID |
![]() |
Add transaxle fluid until the fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening.
| *1 | Filler Nozzle |
After adding fluid, leave it for 30 seconds so that the fluid surface can become still again, and then check that the fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening. (If the fluid level is too low, return to the Add Hybrid Transaxle Fluid procedure.)
Using a 10 mm hexagon socket wrench, temporarily install the filler plug and gasket.
| 3. INSPECT HYBRID TRANSAXLE FLUID |
![]() |
Using a 10 mm hexagon socket wrench, remove the filler plug and gasket.
Check that the fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening. (If the fluid level is too low, return to the Add Hybrid Transaxle Fluid procedure.)
Check for leaks if the quantity of transaxle fluid is low. (If there are no fluid leaks but the amount of the fluid is insufficient, add fluid .
Using a 10 mm hexagon socket wrench, install the filler plug with a new gasket.