Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER PUMP

BRAKE BOOSTER PUMP > REMOVAL

for Preparation Click here



1. REMOVE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
(Click here)


2. REMOVE BRAKE ACTUATOR HOSE


    C296809
  1. Move the clip and remove the brake actuator hose from the brake booster pump assembly.



3. REMOVE FRONT NO. 1 BRAKE TUBE


    C296810
  1. Remove the bolt.

  1. Using a union nut wrench, disconnect the brake line to remove the front No. 1 brake tube from the brake booster pump assembly.



4. REMOVE NO. 1 BRAKE TUBE CLAMP BRACKET


    C296811
  1. Remove the bolt and No. 1 brake tube clamp bracket from the brake booster pump assembly.



5. REMOVE BRAKE BOOSTER PUMP ASSEMBLY


    C250035
  1. Disconnect the 2 connectors from the brake booster pump assembly.



    C249857E01
  1. Remove the 2 nuts, brake booster pump assembly, 2 brake actuator case collars and 2 brake booster pump bushings from the brake actuator bracket assembly.
    Text in Illustration 
    *1
    Union
    *2
    Connector
    *3
    Stud

    NOTICE:
    1. Do not carry the brake booster pump assembly by the parts shown in bold (*1, *2 and *3) in the illustration.
    2. Do not drop the brake booster pump assembly when carrying it. If the brake booster pump assembly has been dropped, replace it with a new one.
    3. Be careful not to allow any brake fluid to enter the connector.
    4. Do not kink or damage the brake lines. If they are damaged, replace them with new ones.



6. REMOVE FRONT WHEEL LH


7. REMOVE ENGINE UNDER COVER LH


8. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY


    C250036
  1. Disengage the 2 clamps to separate the frame wire from the brake actuator bracket assembly.



    C249860
  1. Remove the 3 bolts and brake actuator bracket assembly.



    C256174
  1. Disengage the clamp to separate the frame wire from the brake actuator bracket assembly.

    NOTICE:
    Do not kink or damage the brake lines.