Home › General › SPECIFICATIONS › HYBRID / BATTERY CONTROL

HYBRID / BATTERY CONTROL > SERVICE DATA



Reserve Tank Cap (for Inverter) 
Item
Specified Condition
Standard value (for brand-new cap)
94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.6 to 18 psi)
Minimum standard value (for used cap)
94 kPa (1.0 kgf/cm2, 13.6 psi)

Relay 
Item
Tester Connection
Specified Condition
IGCT relay
Resistance
3 - 5
10 kΩ or higher
(No auxiliary battery voltage is applied across terminals 1 and 2)
3 - 5
Below 1 Ω
(Auxiliary battery voltage is applied across terminals 1 and 2)

Hybrid Battery Junction Block 
SMRB
Resistance
A-1 (+) - P5-1 (CBI)
10 kΩ or higher
(Auxiliary battery voltage is not applied between terminals M40- 1 (SMRB) and M40-2 (GND))
Below 1 Ω
(Auxiliary battery voltage is applied between terminals M40- 1 (SMRB) and M40-2 (GND))
M40-1 (SMRB) - M40-2 (GND)
25.0 to 59.0 Ω (at -40 to 80°C (-40 to 176°F))
SMRG
Resistance
c1-1 (-) - P4-1 (CEI)
10 kΩ or higher
(Auxiliary battery voltage is not applied between terminals M40- 3 (SMRG) and M40-2 (GND))
Below 1 Ω
(Auxiliary battery voltage is applied between terminals M40- 3 (SMRG) and M40-2 (GND))
M40-3 (SMRG) - M40-2 (GND)
25.0 to 59.0 Ω (at -40 to 80°C (-40 to 176°F))
SMRP
Resistance
P4-1 (CEI) - c1-1 (-)
10 kΩ or higher
(Auxiliary battery voltage is not applied between terminals M40- 4 (SMRP) and M40-2 (GND))
28.5 to 31.5 Ω
(Auxiliary battery voltage is applied between terminals M40- 4 (SMRP) and M40-2 (GND))
M40-4 (SMRP) - M40-2 (GND)
112 to 274 Ω (at -40 to 80°C (-40 to 176°F))

Service plug grip 
Service plug grip
Always
Below 1 Ω

Combination switch assembly 
EV drive mode switch (pattern select switch assembly)
G63-4 (S) - G63-1 (E)
Below 1 Ω
(EV drive mode switch (pattern select switch assembly) being pushed and held)
10 kΩ or higher
(EV drive mode switch (pattern select switch assembly) not pushed)
Illumination
Auxiliary battery positive (+) → G63-3 (ILL+) Auxiliary battery negative (-) →G63-2 (ILL-)
Illuminates