Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2795    Unmatched Key Code

for Preparation Click here


DESCRIPTION

This DTC is stored when a key with a different vehicle serial number is inserted into the ignition key cylinder.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2795
A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*).
  1. Key
  2. Transponder key ECU assembly
Insert the key into the ignition key cylinder.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation When Malfunction Detected
Hybrid control system cannot be started
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B2795
Different Serial Number

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the key or transponder key ECU assembly, refer to the Registration (Click here).
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Insert and remove each registered key one at a time, and check for DTCs each time (Click here).

    HINT:
    1. Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
    2. If DTC B2795 is stored, check for DTCs with the next key after clearing the DTCs.

    OK:
    DTC B2795 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (any key)
    B
    NG (all keys)
    C



B
Go to step 3

C
Go to step 5
A

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK IGNITION SWITCH (OPERATION)
  1. Check that the ignition switch can be turned to ON using the key for which the DTC was stored.

    OK:
    Ignition switch can be turned to ON using the key (for which the DTC was stored).



NG
REPLACE KEY THAT CANNOT START HYBRID CONTROL SYSTEM
OK


4.REREGISTER MALFUNCTIONING KEY
  1. Clear the DTCs (Click here).

  1. Reregister the key code with the transponder key ECU assembly (Click here).

    OK:
    Registration procedure can be completed.



NG
REPLACE KEY THAT CANNOT START HYBRID CONTROL SYSTEM
OK

END (KEY CODE IS NOT REGISTERED NORMALLY) 

5.REPLACE TRANSPONDER KEY ECU ASSEMBLY
  1. Replace the transponder key ECU assembly (Click here).


NEXT


6.REGISTER KEY
  1. Register the key (Click here).


NEXT


7.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


8.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


9.CHECK FOR DTC
  1. Check for DTCs (Click here).

    HINT:
    1. Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
    2. If DTC B2795 is stored, check for DTCs with the next key after clearing the DTCs.

    OK:
    DTC B2795 is not output.



NG
REPLACE KEY THAT CANNOT START HYBRID CONTROL SYSTEM
OK

END (TRANSPONDER KEY ECU ASSEMBLY WAS DEFECTIVE)