SMART KEY SYSTEM (for Start Function) > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE SMART KEY SYSTEM (for Start Function) |
Customizing with the Techstream
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Smart Key/Access or Warning.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Ignition Available Area (Entry ignition available area) | All | Function that sets the area that the key must be in before the power switch can be operated. | Front or All | Certification ECU (smart key ECU assembly) |
| Engine Start Indicator | ON | Function that turns the smart warning light on the combination meter assembly on or off. | OFF or ON | Certification ECU (smart key ECU assembly) |
| Display | Default | Content | Setting | Relevant ECU |
| Key Low Battery Warning (Warn when key battery becomes weak) | ON | Enables or disables the sounding of the buzzer when the transmitter battery is low and the power switch is turned off after being on (IG) for 20 minutes or more. | OFF or ON | Certification ECU (smart key ECU assembly) |
Entry cancel function (manual operation)
The following functions are disabled when the smart key system is canceled.
When canceling the system through manual operation:
Perform the following procedure to restore the smart key system to the active state from the canceled state.