Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM

VEHICLE PROXIMITY NOTIFICATION SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.


System Name
See Procedure
Power Door Lock Control System
Click here

2.IGNITION SWITCH EXPRESSIONS
  1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Power Switch (Condition)
    Ignition Switch off
    LOCK
    Off (Lock)
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON (IG)
    ON (IG)
    On (IG)
    Ignition Switch ON (READY)
    ON (READY)
    On (Ready)


3.PRECAUTIONS FOR VEHICLE PROXIMITY NOTIFICATION SYSTEM
  1. In the following cases, the volume or tone of the sound might change:

    1. If the vehicle is parked in a very hot or cold environment for an extended period of time (function will return to normal after time passes)

    2. If high pressure water is applied directly to the speaker from the bottom of the vehicle

    3. If the front of the speaker is blocked by mud, snow, ice, etc.

    4. If the entire speaker freezes

  2. In the following cases, it may be difficult to hear the sound from the speaker:

    1. If the environment around the vehicle is very noisy (in a busy intersection or when an emergency vehicle is approaching)

    2. If the listener is behind the vehicle. (Compared to a situation such as when a pedestrian is in front of the vehicle, the sound volume will seem to be lower when the car is reversing. This occurs because the speaker is installed facing the front of the vehicle.)