Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE LIGHTING SYSTEM (INT)
  1. Customizing using the Techstream

    HINT:
    The following items can be customized.

    NOTICE:
    1. When the customer requests a change in a function, first make sure that the function can be customized.
    2. Be sure to make a note of the current settings before customizing.
    3. When troubleshooting a function, first make sure that the function is set to the default setting.


    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON (IG).

    3. Turn the Techstream on.

    4. Enter the following menus: Customize Setting / Illuminated Entry.

    5. Select the setting by referring to the table below.

      Illuminated Entry 
      Tester Display
      Default
      Content
      Setting
      Relevant ECU
      Lighting Time
      15 s
      Changes the lighting time after closing all of the doors. (The lights will fade out immediately in case of turning the ignition switch from off to ACC or ON (IG).)
      7.5 s, 15 s or 30 s
      Main body ECU (Multiplex network body ECU)
      I/L when ACC OFF
      ON
      Lights up the power switch illumination*1 and personal light when the ignition switch is turned from ACC or ON (IG) to off.
      ON or OFF
      I/L ON W/Door Key Unlock
      ON
      Lights up the power switch illumination and personal light when doors are unlocked using a mechanical key or door control transmitter.
      ON or OFF
      Room Light when Aprchd*1
      ON
      Lights up the power switch illumination and personal light when a key enters any actuation area around the doors.
      ON or OFF

      1. *1: w/ Smart Key System