Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU

NAVIGATION ECU > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



2. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET


    E237149
  1. Remove the 4 screws.



    E237150
  1. Disengage the 2 guides and pull the radio and display receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio and display receiver assembly with bracket.



3. REMOVE NO. 1 RADIO RECEIVER BRACKET


    E237153
  1. Remove the 3 screws and No. 1 radio receiver bracket.



4. REMOVE NO. 2 RADIO RECEIVER BRACKET


    E237154
  1. Remove the 3 screws and No. 2 radio receiver bracket.



5. REMOVE EXTENSION MODULE


    E237155
  1. Disconnect the 3 connectors to remove the navigation wire.



    E237156
  1. Disconnect the connector to remove the extension module.