HYBRID TRANSAXLE FLUID > ON-VEHICLE INSPECTION |
| 1. INSPECT HYBRID TRANSAXLE FLUID |
![]() |
Using a 10 mm hexagon socket wrench, remove the filler plug and gasket.
Check that the fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening. (If the fluid level is too low, return to the Add Hybrid Transaxle Fluid procedure.)
Check for leaks if the quantity of transaxle fluid is low. (If there are no fluid leaks but the amount of the fluid is insufficient, add fluid .
Using a 10 mm hexagon socket wrench, install the filler plug with a new gasket.