CYLINDER HEAD > REPAIR |
| 1. REPAIR INTAKE VALVE SEATS |
![]() |
If the seating is too high on the valve face, use 20° and 45° cutters to correct the seat.
| *a | Width |
![]() |
If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.
| *a | Width |
Hand-lap the valve and valve seat with an abrasive compound.
Check the valve seating position.
| 2. REPAIR EXHAUST VALVE SEATS |
![]() |
If the seating is too high on the valve face, use 20° and 45° cutters to correct the seat.
| *a | Width |
![]() |
If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.
| *a | Width |
Hand-lap the valve and valve seat with an abrasive compound.
Check the valve seating position.