Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT FLOOR COVER RH


    B301488E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301489
  1. Disengage the 3 guides and remove the front floor cover RH.



3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



5. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    B301683
  1. Disengage the 3 clips and remove the No. 2 instrument panel register assembly.



6. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B301684E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301685
  1. Using a moulding remover, disengage the 12 clips and 10 guides to remove the instrument cluster finish panel garnish.



7. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY


    B301687
  1. Disengage the claw and 4 clips to remove the center instrument panel register assembly.



8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301688
  1. Using a clip remover, remove the 2 clips.



    B301689
  1. Disengage the 4 claws and 9 guides and remove the instrument cluster finish panel sub-assembly.



9. REMOVE COMBINATION METER ASSEMBLY


    E244444
  1. Remove the 2 screws.



    E244445
  1. Disengage the 3 clips as shown in the illustration.



    E244446
  1. Disconnect the 2 connectors.

  1. Disengage the clamp and remove the combination meter assembly.