Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY BLOWER

BATTERY BLOWER > INSPECTION

for Preparation Click here



1. INSPECT BATTERY COOLING BLOWER ASSEMBLY


    A309720E01
  1. Inspect the filter.
    Text in Illustration 
    *a
    Filter

    Standard:
    No clogs or damage.

    NOTICE:
    If the filter is damaged, replace the battery cooling blower assembly.



  1. Clean the filter.



      A309716
    1. Remove the battery cooling blower assembly and clean the filter by hand with the filter facing down.

      NOTICE:
      1. Do not use water or any other liquids when cleaning the filter.
      2. Clean the filter by hand.
      3. To prevent damage to the filter, do not use a wire brush or scrubber.
      4. Do not hold the battery cooling blower assembly by the wire harness or fan while cleaning the filter.
      5. Do not allow any foreign matter to enter the battery cooling blower assembly.