Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

HYBRID CONTROL SYSTEM > OPERATION HISTORY DATA

for Preparation Click here



OPERATION HISTORY DATA

HINT:
The power management control ECU records inappropriate operations performed by the driver and the number of abnormal conditions that have been input to the ECU as operation history data.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Powertrain / Hybrid Control / Data List.

  5. Enter the menu to view the number of inappropriate operations or controls that have been performed.

    HINT:
    1. Latest Operation: Among the past occurrences, the number of inappropriate operations or controls that have been performed during the most recent 1 trip detection.
    2. Latest Trip: The number of trips after the occurrence of Latest Operation.
    3. Operation before Latest: The number of occurrences during the trip previous to the Latest Operation.
    4. Trip before Latest: The number of trips after the occurrence of Operation before Latest.


    Inappropriate Operation and History Data 
    Tester Display
    Count Condition
    Shift Gear before READY
    Shift lever moved with READY indicator blinking
    N Range Control in Half Shift
    Shift position cannot be determined
    N Range Control by Busy Shift
    N position control performed due to frequent shifting operation
    Step Accelerator in N Range
    Accelerator pedal depressed in N position
    Auxiliary Battery Low
    Auxiliary battery voltage below 9.5 V (Ignition switch cannot be turned ON (READY))
    HV ECU Intermittent Problems
    Instantaneous open circuit at +B terminal of power management control ECU
    MG2 (Motor) Temperature High
    Motor (MG2) temperature exceeded 162°C(323.6°F)
    MG1 (Generator) Temperature High
    Generator (MG1) temperature exceeded 168°C(384.4°F)
    MG2 (Motor) Inverter Temperature High
    Motor inverter temperature rose and HV system overheat was indicated
    MG1 (Generator) Inverter Temperature High
    Generator inverter temperature rose and HV system overheat was indicated
    Main Battery Low Voltage
    HV battery state of charge dropped below 30%
    Resistor Over Heat
    System main resistor that is connected to SMRP (precharge system main relay) was overheated
    Coolant Heating
    HV coolant temperature exceeded 65°C (149°F)
    Converter Heating
    Boost converter temperature rose and HV system overheat was indicated
    Shift Backward Direction
    Shifted to R while moving forward or to D or B while moving in reverse
    Prevention Control of Staying
    Engine speed stays in resonance frequency band
    Accelerator and Brake Depress
    Both accelerator and brake pedals depressed