FRONT SUSPENSION SYSTEM > GENERAL



OUTLINE
  1. A MacPherson strut type independent suspension is used.

  2. Excellent driving stability and ride comfort have been achieved by optimizing the suspension geometry.



  3. The steering gear box is mounted directly onto the suspension member, which improves steering initial response.


    X101564E01


    Text in Illustration 
    *1
    Front Suspension Support Sub-assembly
    *2
    Front Coil Spring
    *3
    Front Shock Absorber Assembly
    *4
    Front Lower No. 1 Suspension Arm
    *5
    Front Stabilizer Bar
    *6
    Suspension Member (Front Suspension Crossmember Sub-assembly)


SPECIFICATION

Tire Size
195/65R15
215/45R17
Suspension Type
MacPherson Strut
←
Front Wheel Alignment (Unloaded Vehicle)
Tread
1525 mm (60.0 in.)
1515 mm (59.6 in.)
Caster
5°53', 5°40'*
5°51'
Camber
-0°13', -0°07'*
-0°12'
Toe-in
2.0 mm (0.08 in.), 3.0 mm (0.12 in.)*
2.0 mm (0.08 in.)
King Pin Inclination
12°15', 11°52'*
12°10'
  1. *: Russian package or rough road specification models

MAIN FEATURES


  1. Optimized Caster



    1. Optimum caster angle and trail value are featured to provide straight-line stability during low-speed to high-speed ranges and assist steering response during high speed.


      X101565E02


      Text in Illustration 
      *a
      Caster Angle
      *b
      Trail Value
      *c
      King Pin Axis
      *d
      Lower Ball Joint Fulcrum Point



  2. Optimized Camber



    1. The front suspension uses negative camber to reduce the ground contact camber angle of the outer wheel at the time of turning (cornering) which is caused when the vehicle posture changes during cornering, thus offering excellent cornering performance.


      X101566E02


      Text in Illustration 
      *a
      Straight-line
      *b
      Cornering
      *c
      Negative Camber
      -
      -



  3. Optimized King Pin Offset



    1. A small king pin offset is used and the moment which occurs around the king pin axis is made small in order to achieve excellent vehicle stability during braking. When force (F) is applied to the wheel during braking etc., (F) is applied at the tire center ground contact point (A) and the king pin offset radius (L). The power of (F) multiplied by (L) tries to turn the king pin axis. In this way, making the king pin offset smaller produces smaller moment of the king pin axis to provide excellent vehicle stability during braking.


      X101567E02


      Text in Illustration 
      *a
      Rear View
      *b
      Upper View
      *c
      King Pin Axis
      *d
      Tire Contact Center
      *e
      Tire Center Ground Contact Point (A)
      *f
      King Pin Offset (L)
      V100135
      Force (F)
      -
      -