MULTIPLEX COMMUNICATION SYSTEM > GENERAL



OUTLINE
  1. The multiplex communication system uses the 3 communication protocols (CAN, LIN and AVC-LAN) to achieve a streamlined wiring harness configuration.

    Protocol
    Outline
    CAN (Controller Area Network)
    The HS (High Speed)-CAN is used for the power train, chassis and body electrical systems. The HS-CAN consists of the V1 bus, V2 bus, power management bus and the parking assist bus. The power management control ECU with gateway function is used to transmit data between the buses.
    LIN (Local Interconnect Network)
    LIN is used for local area networking, in which the system has a respective bus for each body electrical system.
    Audio Visual Communication-Local Area Network (AVC-LAN)
    AVC-LAN is used for communication only between Audio Visual system components.

  2. There is no direct communication between CAN, LIN and AVC-LAN networks because these multiplex communication systems are incompatible. CAN, LIN and AVC-LAN are separate networks. Because these are separate networks, some ECUs serve as gateways for the transfer of data, allowing communication between CAN and LIN networks.


MAIN FEATURES


  1. Multiplex Communication



    1. Generally speaking, multiplex communication refers to the use of serial communication data that consists of bits and frames in order to exchange information among various ECUs. This allows for a reduction of the amount of wiring on the vehicle. A bit is the basic unit of communication that is used to represent the information. A bit is represented by binary values of "0" or "1".For CAN communication, a differential voltage drive is used to represent the binary values of "0" or "1". This "differential voltage drive" reduces the effects of electrical interference.


      Y100741E02



  2. Differences between CAN, LIN and AVC-LAN

    1. The protocols, which are the rules for establishing data communication, differ between the CAN, LIN and AVC-LAN. If the ECUs in the networks use different frameworks for their data, such as communication speed, communication wire, and signals, they will be unable to understand each other. Therefore, protocols (rules) must be established among them.

    2. Compared to the LIN, and AVC-LAN, the CAN features high-speed data transmission. Therefore, the CAN is able to transmit larger amounts of data faster than other protocols. This feature makes it possible to transmit data accurately for the power train, chassis and body electrical systems, which requires large amounts of data to be transmitted in short periods of time.

      Protocol
      CAN
      LIN
      AVC-LAN
      Communication Speed
      500 kbps*
      9.6 kbps*
      Max. 17.8 kbps*
      Communication Wire
      Twisted-pair Wire
      AV Single Wire
      Twisted-pair Wire
      Drive Type
      Differential Voltage Drive
      Single Wire Voltage Drive
      Differential Voltage Drive
      Data Length
      1-8 Byte (Variable)
      2, 4, 8 Byte (Variable)
      0-32 Byte (Variable)

      HINT:
      bps*: abbreviation for "Bits Per Second", indicating the number of bits that can be transmitted per second.



    3. A twisted-pair wire is used for CAN and AVC-LAN communication. An Automobile Vinyl (AV) single wire is used for LIN communication.

      Communication Wire
      Outline
      Twisted-pair Wire
      Y100743
      This communication wire is a pair of twisted lines Communication is driven by applying different voltages to the two lines in order to send a single signal. This system, which is called a "Differential Voltage Drive", reduces noise.
      AV Single Wire
      Y100744
      This is a lightweight single communication wire that consists of a single core line surrounded by insulation. Voltage is applied to this line in order to drive communication, and this system is called a "Single Wire Voltage Drive".


      Y100742E02