FRONT STABILIZER BAR > INSTALLATION |
| 1. INSTALL FRONT STABILIZER BAR BUSHING LH |
![]() |
Install the front stabilizer bar bushing to the front stabilizer bar as shown in the illustration.
| *1 | Front of the Vehicle |
| *2 | Inside of the Vehicle |
| *3 | Stopper |
| *4 | Dust Lip |
| 2. INSTALL FRONT STABILIZER BAR BUSHING RH |
| 3. INSTALL FRONT STABILIZER BAR |
Install the front stabilizer bar to the front suspension crossmember sub-assembly so that the identification mark is positioned on the right side of the vehicle.

| *1 | Identification Mark | *2 | Front of the Vehicle |
| *3 | Top of the Vehicle | - | - |
| 4. INSTALL FRONT SUSPENSION MEMBER FRONT BRACE LH |
![]() |
Install the front suspension member front brace LH with the 4 bolts.
| *1 | Protrusion |
| 5. INSTALL FRONT SUSPENSION MEMBER FRONT BRACE RH |
![]() |
Install the front suspension member front brace RH with the 4 bolts.
| *1 | Protrusion |
| 6. TEMPORARILY INSTALL FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH |
![]() |
Temporarily install the front No. 1 lower suspension arm LH to the front suspension crossmember with the 2 bolts and nut.
| 7. CONNECT FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH |
![]() |
Install the front No. 1 lower suspension arm sub-assembly to the front lower ball joint with the bolt and 2 nuts.
| 8. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Install the front stabilizer link assembly LH with the 2 nuts.
| *1 | Upper Side |
| *2 | Lower Side |
| 9. INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
| 10. INSTALL FRONT WHEELS |
| 11. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 12. FULLY TIGHTEN FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH |
![]() |
Fully tighten the bolt A and B.
| 13. INSTALL NO. 2 ENGINE UNDER COVER |
| 14. INSTALL NO. 1 ENGINE UNDER COVER |
| 15. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |