REAR BRAKE FLEXIBLE HOSE > REMOVAL |
| 1. PRECAUTION (w/ Navigation System for HDD) |
| 2. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISABLE BRAKE CONTROL |
Wait at least 2 minutes after the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) battery terminal.
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 6. REMOVE REAR WHEEL |
| 7. DRAIN BRAKE FLUID |
| 8. REMOVE REAR BRAKE TUBE FLEXIBLE HOSE (for LH Side) |
Using a union nut wrench, disconnect the 2 brake lines while holding the rear brake tube flexible hose with a wrench.

Remove the clip, bolt and rear brake tube flexible hose.
| 9. REMOVE REAR BRAKE TUBE FLEXIBLE HOSE (for RH Side) |
Using a union nut wrench, disconnect the 2 brake lines while holding the rear brake tube flexible hose with a wrench.

Remove the 2 clips and rear brake tube flexible hose.
| 10. REMOVE REAR FLEXIBLE HOSE |
![]() |
Using a union nut wrench, Disconnect the brake line while holding the rear flexible hose with a wrench.
![]() |
Remove the clip and separate the rear flexible hose from the brake line.
![]() |
Remove the union bolt, gasket and rear flexible hose.