Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › SFI SYSTEM (w/o EGR System)

DTC    P0630    VIN not Programmed or Mismatch - ECM / PCM

for Preparation Click here


MONITOR DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is not accurate.

DTC No.
DTC Detection Condition
Trouble Area
P0630
When either of the following conditions is met (1 trip detection logic).
  1. The VIN is not stored in the ECM.
  2. The VIN input into the ECM is not accurate.
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    DTC P0630 is output
    A
    DTC P0630 and other DTCs are output
    B

    NOTICE:
    If P0630 is stored, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the intelligent tester when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.

    HINT:
    If any DTCs other than P0630 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART (Click here)
A


2.INPUT VIN
  1. Input the VIN (Click here).


NEXT

END