Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Headlight Cleaner Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the conditions (on or off) of the headlight cleaner switch assembly.

WIRING DIAGRAM


E182429E02


INSPECTION PROCEDURE

1.INSPECT HEADLIGHT CLEANER CONTROL RELAY (H SIGNAL)


    E144468E22
  1. Disconnect the A44 headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A44-2 (H) - Body ground
    Light control switch in head and headlight cleaner switch on
    11 to 14 V
    A44-2 (H) - Body ground
    Headlight cleaner switch off
    Below 1 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Headlight Cleaner Control Relay)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY
E161932E06
  1. Remove the headlight cleaner switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (E) - 4 (B)
    Headlight cleaner switch off
    10 kΩ or higher
    1 (E) - 4 (B)
    Headlight cleaner switch on
    Below 1 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Headlight Cleaner Switch Assembly)



NG
REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (MAIN BODY ECU - HEADLIGHT CLEANER CONTROL RELAY)