LIGHTING SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG SW | Power switch IG signal/ON or OFF | ON: Power switch on (IG) OFF: Power switch off | - |
| RR Door Courtesy SW | Rear door courtesy light switch RH/ON or OFF | ON: Rear door RH or LH open OFF: Rear door RH and LH closed | - |
| RL Door Courtesy SW | Rear door courtesy light switch LH/ON or OFF | ON: Rear door RH or LH open OFF: Rear door RH and LH closed | - |
| Back Door Courtesy SW | Back door courtesy switch signal/ON or OFF | ON: Back door open OFF: Back door closed | - |
| FR Door Courtesy | Front door courtesy light switch RH signal/ON or OFF | ON: Front door RH open OFF: Front door RH closed | - |
| FL Door Courtesy | Front door courtesy light switch LH signal/ON or OFF | ON: Front door LH open OFF: Front door LH closed | - |
| Dimmer SW | Dimmer switch high position signal/ON or OFF | ON: Dimmer switch in high or high flash position OFF: Dimmer switch in low position | - |
| Passing Light SW | Dimmer switch high flash position (pass) signal/ON or OFF | ON: Dimmer switch in high flash position OFF: Dimmer switch not in high flash position | - |
| Rear Fog Light SW | Rear fog light switch signal/ON or OFF | ON: Rear fog light switch on OFF: Rear fog light switch off | - |
| Front Fog Light SW | Front fog light switch signal/ON or OFF | ON: Front fog light switch on OFF: Front fog light switch off | - |
| Auto Light SW | Light control switch AUTO position signal/ON or OFF | ON: Light control switch in AUTO position OFF: Light control switch not in AUTO position | - |
| Head Light SW (Head) | Light control switch head position signal/ON or OFF | ON: Light control switch in head position OFF: Light control switch not in head position | - |
| Head Light SW (Tail) | Light control switch tail position signal/ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch in neither tail nor head position | - |
| Illumination Rate Info | Illumination rate information/0 ms. to 99.99 ms. | Value is output according to ambient light levels | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Headlight Low Beam State | Low beam headlight state/ON or OFF | ON: Low beam headlights on OFF: Low beam headlights off | - |
| +B | IG power supply voltage value/0 to 19.75 V | 11 to 14 V | - |
| Height Sens Pw Supply Val | Height control sensor power supply value/0 to 6.25 V | Approx. 5 V | - |
| Rr Height Sens Signal Val | Rear height control sensor signal value/0 to 5 V | Approx. 2.5 V (When vehicle is level) | Value changes according to vehicle height |
| Vehicle Speed | Vehicle speed/0 to 327.67 km/h | Condition can be displayed | - |
| Rear Height Adjust Valid Flag | Rear height adjustment range/VALID or INVALID | Condition can be displayed | - |
| Init Writing Count | Number of times for initialization/0 to 255 | Condition can be displayed | - |
| Number Of Trouble Codes | Number of trouble codes/0 to 255 | Condition can be displayed | - |
| ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Taillight Relay | Taillight relay | ON/OFF | - |
| Headlight Relay | Headlight relays | ON/OFF | - |
| Head Light Hi | High beam headlights | ON/OFF | - |
| Front Fog Light Relay | Front fog light relay | ON/OFF | Light control switch is in tail position |
| Rear Fog Light Relay | Rear fog light relay | ON/OFF | Light control switch is in tail position |
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Drive The Leveling Motor UP*1 | Leveling motor upward operation | ON/OFF | ON: Move up OFF: Stop |
| Drive The Leveling Motor DOWN*1 | Leveling motor downward operation | ON/OFF | ON: Move down OFF: Stop |