Home › Engine / Hybrid System › 2ZR-FXE COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE FRONT SPOILER COVER (w/ Front Spoiler)


2. REMOVE ENGINE UNDER COVER


3. REMOVE INLET AIR CLEANER ASSEMBLY


    A212313
  1. Separate the water by-pass hose from the inlet air cleaner assembly.

  1. Separate the wire harness clamp from the inlet air cleaner assembly.

  1. Remove the 3 bolts and inlet air cleaner assembly.



4. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the reservoir tank cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the local regulations.



  1. Loosen the cylinder block drain cock plug.

    HINT:
    The plug is on the back of the generator on the exhaust manifold side.



    A216061E01


    Text in Illustration 
    *1
    Reservoir Tank Cap
    *2
    Cylinder Block Drain Cock Plug
    *3
    Radiator Drain Cock Plug
    *4
    Air Release Valve



5. REMOVE ENGINE WATER PUMP ASSEMBLY
  1. Disconnect the connector from the engine water pump assembly.



    A216462
  1. Remove the 5 bolts and engine water pump assembly from the timing chain cover.



    A214926
  1. Remove the gasket from the engine water pump assembly.