DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0125 | Engine coolant temperature does not reach closed-loop enabling temperature for 20 minutes (this period varies with engine start engine coolant temperature) (2 trip detection logic) |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0125 is output | A |
| DTC P0125 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY |
Remove the water inlet with thermostat sub-assembly (Click here).
Check the valve opening temperature of the water inlet with thermostat sub-assembly.
Reinstall the water inlet with thermostat sub-assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | ||
| ||