Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Customize Setting / Illuminated Entry.

  5. Select the setting by referring to the table below.

    Illuminated Entry 
    Tester Display
    Default
    Content
    Setting
    Lighting Time
    15 s
    Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC or IG).)
    7.5 s, 15 s or 30 s
    I/L when ACC OFF
    ON
    Lights up power switch illumination, front interior lights, rear interior light and footwell lights when the power switch is turned from on (ACC or IG) to off.
    ON or OFF
    I/L ON W/Door Key Unlock
    ON
    Lights up power switch illumination, front interior lights, rear interior light and footwell lights when doors are unlocked using a mechanical key or door control transmitter.
    ON or OFF
    Light Control
    ON
    Dims (ON setting) or turns off (OFF setting) the footwell lights under the following conditions:
    Power switch on (IG), shift lever not in P, and all doors closed.
    ON or OFF
    Room Light when Aprchd
    ON
    Lights up the power switch illumination, front interior lights, rear interior light and footwell lights when a key enters any actuation area around the doors.
    ON or OFF
    Inside Foot Light
    ON
    ON/OFF of footwell light control function.
    ON or OFF