LIGHTING SYSTEM > CUSTOMIZE PARAMETERS |
| CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Customize Setting / Light Control.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Disp Ex ON Sen | Normal | Changes the ambient brightness level required to dim the lights such as the indicator lights of the combination meter, A/C indicator light and clock.*A | Light2, Light1, Normal, Dark1 or Dark2 | Main Body ECU (Multiplex Network Body ECU) |
| Disp Ex OFF Sen | Normal | Changes the ambient brightness level required to cancel the dimming of the lights such as the indicator lights of the combination meter, A/C indicator light and clock.*B | Light2, Light1, Normal, Dark1 or Dark2 | |
| Response Time | 0.1 s | Changes the delay timing of lighting the taillights when going into a tunnel when the light control switch is in the AUTO position | 0.1 s or 1.0 s | |
| Sensitivity | Normal | Adjusts the sensitivity of the automatic light control system.*C | Light2, Light1, Normal, Dark1 or Dark2 | |
| DRL Function | On | ON/OFF of the DRL function | On or Off |
| Brightness level required to dim the lights | ![]() | ||||
| Setting | Dark2 | Dark1 | Normal | Light1 | Light2 |
| Brightness level required to cancel the dimming of the lights | ![]() | ||||
| Setting | Dark2 | Dark1 | Normal | Light1 | Light2 |
| Sensitivity of the automatic light control system | ![]() | ||||
| Setting | Dark2 | Dark1 | Normal | Light1 | Light2 |
| CUSTOMIZING FUNCTION WITH MULTI-DISPLAY (for Navigation Receiver Type) |
Turn the power switch on (IG).
Enter the following menus: SETUP / Vehicle / Vehicle Customization / Light Settings.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Headlamps-On Sensitivity | 0 | Adjusts the sensitivity of the automatic light control system.*A | -2, -1, 0, +1 or +2 | Main Body ECU (Multiplex Network Body ECU) |
| Sensitivity of the automatic light control system | ![]() | ||||
| Setting | -2 | -1 | 0 | +1 | +2 |
| CUSTOMIZING FUNCTION WITH MULTI-DISPLAY (for Radio and Display Type) |
Turn the power switch on (IG).
Enter the following menus: SETUP / Vehicle.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Light Sensor Sensitivity | 0 | Adjusts the sensitivity of the automatic light control system.*A | -2, -1, 0, +1 or +2 | Main Body ECU (Multiplex Network Body ECU) |
| Sensitivity of the automatic light control system | ![]() | ||||
| Setting | -2 | -1 | 0 | +1 | +2 |