AIR CONDITIONING SYSTEM > IG Power Source Circuit |

| 1.INSPECT A/C AMPLIFIER |
![]() |
Remove the A/C amplifier with its connectors still connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L17-1 (IG+) - L17-14 (GND) | Power switch off | Below 1 V |
| L17-1 (IG+) - L17-14 (GND) | Power switch on (IG) | 11 to 14 V |
| *1 | Component with harness connected (A/C Amplifier) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY) |
![]() |
Disconnect the A/C amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L17-1 (IG+) - Body ground | Power switch off | Below 1 V |
| L17-1 (IG+) - Body ground | Power switch on (IG) | 11 to 14 V |
| *1 | Front view of wire harness connector (to A/C Amplifier) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L17-14 (GND) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to A/C Amplifier) |
|
| ||||
| OK | ||
| ||