AIR CONDITIONING SYSTEM > Back-up Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY) |
![]() |
Disconnect the A/C amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L17-21 (B) - Body ground | Power switch off | 11 to 14 V |
| *1 | Front view of wire harness connector (to A/C Amplifier) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BODY GROUND) |
![]() |
Disconnect the A/C amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L17-14 (GND) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to A/C Amplifier) |
|
| ||||
| OK | ||
| ||