WIPER AND WASHER SYSTEM > Headlight Signal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY) |
Disconnect the A44 headlight cleaner control relay connector.
Disconnect the 2C instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A44-1 (HDLO) - 2C-35 | Always | Below 1 Ω |
| A44-1 (HDLO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the instrument panel junction block assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2C-35 - MB-25 (HDLO) | Always | Below 1 Ω |
| *1 | Component without harness connected (Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | ||
| ||