LIGHTING SYSTEM > Headlight Signal Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Lo Beam St | Low beam headlight state/ON or OFF | ON: Low beam headlight on OFF: Low beam headlight off | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (INTEGRATION RELAY - ECU) |
![]() |
Disconnect the A48 headlight leveling ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A48-3 (HDLP) - Body ground | Light control switch in head position | 11 to 14 V |
| *1 | Front view of wire harness connector (to Headlight Leveling ECU assembly) |
|
| ||||
| OK | ||
| ||