Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Signal Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU assembly detects the low beam headlights status.

WIRING DIAGRAM


E178006E06


INSPECTION PROCEDURE

NOTICE:
First check that the low beam headlights operate normally.

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body Electrical / HL Auto Leveling / Data List.

  1. Read the display on the intelligent tester.

    HL Auto Leveling 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Lo Beam St
    Low beam headlight state/ON or OFF
    ON: Low beam headlight on
    OFF: Low beam headlight off
    -

    OK:
    Normal condition listed above is displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (INTEGRATION RELAY - ECU)


    E136327E31
  1. Disconnect the A48 headlight leveling ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A48-3 (HDLP) - Body ground
    Light control switch in head position
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Headlight Leveling ECU assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)