STEERING COLUMN ASSEMBLY > REASSEMBLY |
| 1. INSTALL POWER STEERING MOTOR ASSEMBLY |
![]() |
Install a new electric power steering motor shaft damper to the electric power steering column sub-assembly.
![]() |
Install a new electric power steering motor shaft spacer to the electric power steering column sub-assembly.
![]() |
Temporarily install the power steering motor assembly to the electric power steering column sub-assembly with the 2 bolts.
![]() |
Secure the steering column assembly in a vice using aluminum plates and a piece of cloth.
![]() |
Using SST, turn the steering main shaft once 180 degrees to the left and then 180 degrees to the right at a speed of 60 rpm, and repeat 2 to 3 times to adjust the axis centering of the power steering motor assembly.
Remove the steering column assembly from the vice.
![]() |
Tighten the 2 bolts.
![]() |
Secure the steering column assembly in a vice using aluminum plates and a piece of cloth.
![]() |
Measure the turning torque of the steering main shaft using SST.
![]() |
Engage the claw to install the torque sensor harness connector.
for LHD:
![]() |
Install 2 new clamps and each tape to the wire harness as shown in the illustration.
| *1 | 175 to 195 mm (6.89 to 7.67 in.) |
| *2 | 230 to 250 mm (9.06 to 9.84 in.) |
| *3 | 220 to 240 mm (8.67 to 9.44 in.) |
| *4 | Wrap the Tape In This Area |
| *5 | 19 mm (0.75 in.) |
| *6 | 59° |
| *7 | 65° |
for RHD:
![]() |
Install 2 new clamps and each tape to the wire harness as shown in the illustration.
| *1 | 230 to 250 mm (9.06 to 9.84 in.) |
| *2 | 175 to 195 mm (6.89 to 7.67 in.) |
| *3 | 220 to 240 mm (8.67 to 9.44 in.) |
| *4 | Wrap the Tape In This Area |
| *5 | 45° |
| *6 | 59° |