SIDE AIRBAG SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE REAR NO. 2 FLOOR BOARD |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 6. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 8. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 7 claws and remove the rear door scuff plate LH.
| 9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
| 10. REMOVE CENTER PILLAR LOWER GARNISH |
![]() |
Disengage the 2 claws and 2 clips, and remove the center pillar lower garnish LH.
| 11. REMOVE SIDE AIRBAG SENSOR |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Disconnect the connector.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.

| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
![]() |
Remove the bolt and side airbag sensor.