REAR AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL REAR AIRBAG SENSOR |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the nut.
![]() |
Connect the connector to the rear airbag sensor.
Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

| *1 | Outer Connector Locking Sleeve | - | - |
Check that there is no looseness in the installation parts of the rear airbag sensor.
| 2. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT (for RH Side) |
![]() |
Install the No. 1 hybrid battery intake duct with the 2 clips.
| 3. INSTALL REAR FLOOR BOARD SPACER (for RH Side) |
![]() |
Install the rear floor board spacer with the 2 clips.
| 4. INSTALL REAR NO. 1 FLOOR BOARD (for RH Side) |
![]() |
Engage the 2 claws and 2 clips.
Install the rear No. 1 floor board with the bolt.
| 5. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY (for RH Side) |
![]() |
Engage the claw and 2 clips to install the rear No. 2 floor board sub-assembly.
| 6. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY (for RH Side) |
![]() |
Engage the 2 claws and 2 clips to install the rear No. 1 floor board sub-assembly.
| 7. INSTALL REAR SIDE SEATBACK ASSEMBLY |
| 8. INSTALL REAR DOOR SCUFF PLATE |
![]() |
Engage the 7 claws to install the rear door scuff plate LH.
| 9. INSTALL REAR SEAT CUSHION ASSEMBLY |
![]() |
Engage the 2 guides of the seat cushion to the seatback.
| *1 | 100 mm (3.94 in.) or less |
| *2 | Guide |
| *3 | Hook |
Engage the 2 front hooks of the seat cushion to the vehicle body.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Engage the 2 guides to install the rear No. 3 floor board.
| 12. INSTALL REAR DECK FLOOR BOX |
Install the rear deck floor box.
| 13. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Engage the 3 guides <A>.
Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.
| 14. PERFORM DIAGNOSTIC SYSTEM CHECK |
Perform a diagnostic system check (Click here).
| 15. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).