FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL |
| 1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH |
| 2. DISCONNECT NO. 3 INSTRUMENT PANEL WIRE |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Slide the slider to release the lock, and then disconnect the connector.
| *1 | Slider |
| 3. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY |
Disconnect each connector.
Disengage the 2 clamps.

Remove the 2 bolts <B>.
Remove the 2 passenger airbag bolts <A>.

| *1 | Passenger Airbag Bolt <A> | *2 | Bolt <B> |
Pull the upper instrument panel assembly in the direction indicated by the arrow to disengage the 2 claws and 4 clips.
Pull the upper instrument panel assembly in the direction indicated by the arrow to disengage the 5 claws and remove the upper instrument panel assembly.

| 4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY |
![]() |
Remove the 2 screws and 2 clamps.
![]() |
Lean the instrument panel and disengage the 3 hooks as shown in the illustration.
![]() |
Disengage the 3 hooks to remove the front passenger airbag assembly from the instrument panel safety pad assembly as shown in the illustration.
| 5. REMOVE NO. 3 INSTRUMENT PANEL WIRE |
![]() |
Disengage the clamp.
Separate the No. 3 instrument panel wire from the front passenger airbag assembly clamp.
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
Disconnect the airbag connector to remove the No. 3 instrument panel wire from the front passenger airbag assembly.