Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

HINT:
Refer to the procedure up to Remove Center Instrument Cluster Finish Panel Garnish (Click here).



2. DISCONNECT NO. 3 INSTRUMENT PANEL WIRE
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B232537E01
  1. Slide the slider to release the lock, and then disconnect the connector.
    Text in Illustration 
    *1
    Slider

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



3. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY
  1. Disconnect each connector.



  1. Disengage the 2 clamps.


    B223498

  1. Remove the 2 bolts <B>.



  1. Remove the 2 passenger airbag bolts <A>.


    B223499E01


    Text in Illustration 
    *1
    Passenger Airbag Bolt <A>
    *2
    Bolt <B>

  1. Pull the upper instrument panel assembly in the direction indicated by the arrow to disengage the 2 claws and 4 clips.



  1. Pull the upper instrument panel assembly in the direction indicated by the arrow to disengage the 5 claws and remove the upper instrument panel assembly.


    B223500E01



4. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

CAUTION:
When storing the front passenger airbag assembly, keep the airbag deployment side facing upward.



    B232538
  1. Remove the 2 screws and 2 clamps.



    B232540
  1. Lean the instrument panel and disengage the 3 hooks as shown in the illustration.



    B232546
  1. Disengage the 3 hooks to remove the front passenger airbag assembly from the instrument panel safety pad assembly as shown in the illustration.



5. REMOVE NO. 3 INSTRUMENT PANEL WIRE


    B232541E01
  1. Disengage the clamp.

  1. Separate the No. 3 instrument panel wire from the front passenger airbag assembly clamp.

  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the airbag connector to remove the No. 3 instrument panel wire from the front passenger airbag assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.