Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



  1. Temporarily install the curtain shield airbag assembly with the 5 hooks.


    B228040

    NOTICE:
    Do not twist the curtain shield airbag assembly when installing it.



  1. Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers.


    B228039




      C141265E04
    1. Install 4 new pins as shown in the illustration.
      Text in Illustration 
      *1
      Pin
      *2
      Clip
      *3
      Airbag
      *4
      Body
      *5
      Spacer

      NOTICE:
      Make sure that the pins of the clips are pushed in firmly.



  1. Install the 5 bolts.


    B228038

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



    B228037
  1. Connect the curtain shield airbag connector.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the lock to install the airbag connector.



2. INSTALL ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedure from Install Roof Headlining Assembly (Click here).



3. PERFORM DIAGNOSTIC SYSTEM CHECK
  1. Perform a diagnostic system check (Click here).



4. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).