CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION |
| 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY |
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Temporarily install the curtain shield airbag assembly with the 5 hooks.

Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers.

![]() |
Install 4 new pins as shown in the illustration.
| *1 | Pin |
| *2 | Clip |
| *3 | Airbag |
| *4 | Body |
| *5 | Spacer |
Install the 5 bolts.

![]() |
Connect the curtain shield airbag connector.
Push in the lock to install the airbag connector.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. PERFORM DIAGNOSTIC SYSTEM CHECK |
Perform a diagnostic system check (Click here).
| 4. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).