Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).



2. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedure up to Remove Roof Headlining Assembly (Click here).



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

CAUTION:
When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B228036E01
  1. Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 5 bolts.


    B228038



  1. Remove the 4 clips.


    B228039




      C141263E05
    1. Using a clip remover, remove the 4 pins.
      Text in Illustration 
      *1
      Pin
      *2
      Clip
      *3
      Airbag
      *4
      Body



    2. C141264E09
    3. Using a screwdriver with the tip wrapped with protective tape, separate the 4 clips and curtain shield airbag assembly from the body as shown in the illustration.
      Text in Illustration 
      *1
      Clip
      *2
      Airbag
      *3
      Body
      *4
      Spacer



  1. Disengage the 5 hooks to remove the curtain shield airbag assembly.


    B228040

  1. Remove the 4 clips and 4 spacers from the curtain shield airbag assembly.