Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)


  1. Disconnect the R23 ECU connector.


    B174139E04

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R23-1 (B) - R23-2 (E)
    R - W-B
    +B Power supply
    Power switch off
    11 to 14 V
    R23-5 (IG) - R23-2 (E)
    B - W-B
    Power switch power supply
    Power switch off
    Below 1 V
    R23-5 (IG) - R23-2 (E)
    B - W-B
    Power switch power supply
    Power switch on (IG)
    11 to 14 V
    R23-2 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the R23 ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    R23-7 (OPN) - R23-2 (E)
    SB - W-B
    Sliding roof motor open
    Power switch on (IG), OPEN switch on
    Below 1 V
    R23-7 (OPN) - R23-2 (E)
    SB - W-B
    Sliding roof motor open
    Power switch on (IG), OPEN switch off
    11 to 14 V
    R23-9 (CLS) - R23-2 (E)
    BR - W-B
    Sliding roof motor close
    Power switch on (IG), CLOSE switch on
    Below 1 V
    R23-9 (CLS) - R23-2 (E)
    BR - W-B
    Sliding roof motor close
    Power switch on (IG), CLOSE switch off
    11 to 14 V
    If the result is not as specified, the sliding roof ECU (sliding roof drive gear sub-assembly) may have a malfunction.