DYNAMIC RADAR CRUISE CONTROL SYSTEM > OPERATION CHECK |
| INPUT SIGNAL CHECK |
![]() |
Connect the intelligent tester to the DLC3.
Check the cruise control main switch using the Data List function of the intelligent tester (ON-OFF, - SET and + RES).
| *1 | ON/OFF |
| *2 | - SET |
| *3 | + RES |
| INSPECT MODE SWITCH |
![]() |
Turn the power switch on (IG).
| *1 | ON/OFF |
| *2 | MODE |
Turn the cruise control main switch on. Then push the main switch to MODE for 1 second or more to change to the constant speed control mode. Check that "RADAR READY" goes off on the display.
![]() |
Check that the cruise main indicator light (vehicle-to-vehicle distance control mode) goes off and the cruise main indicator light (constant speed control mode) illuminates.
| *1 | Multi-information Display |
| *2 | Cruise Main Indicator Light (Vehicle-to-vehicle distance control mode) |
| *3 | Cruise Main Indicator Light (Constant speed control mode) |
| INSPECT STEERING PAD SWITCH ASSEMBLY |
Turn the power switch on (IG).
Turn the cruise control main switch (ON-OFF button) on.
Turn on the vehicle-to-vehicle distance control switch of the steering pad switch.
Check that the indication of the vehicle-to-vehicle distance, which is shown on the multi-information display on the combination meter, changes from long to middle to short in that order.

| *1 | Steering Wheel | *2 | Steering Pad Switch |
| *3 | Distance Control Switch | *4 | Multi-information Display |
| *5 | Long | *6 | Middle |
| *7 | Short | *8 | Combination Meter |