DYNAMIC RADAR CRUISE CONTROL SYSTEM > FAIL-SAFE CHART |
| Constant speed control mode and vehicle-to-vehicle distance control mode: |
![]() |
| *1 | Multi-information Display |
| *2 | Master Warning Light |
| *3 | Cruise Main Indicator Light (Constant speed control mode) |
| *4 | Cruise Main Indicator Light (Vehicle-to-vehicle distance control mode) |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
| Millimeter wave radar sensor or driving support ECU country specification information malfunction | Turn cruise control main switch (ON-OFF button) on again |
| Vehicle-to-vehicle distance control mode: |
![]() |
| *1 | Multi-information Display |
| *2 | Master Warning Light |
| *3 | Cruise Main Indicator Light (Vehicle-to-vehicle distance control mode) |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
|
| Power switch on (IG) again |
| Vehicle-to-vehicle distance control mode: |
![]() |
| *1 | Multi-information Display |
| *2 | Master Warning Light |
| *3 | Cruise Main Indicator Light (Vehicle-to-vehicle distance control mode) |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
| There is dirt on millimeter wave radar sensor | Recover from condition on left (RESUME operation is possible after recovery) |
|
|
|
| Constant speed control mode and vehicle-to-vehicle distance control mode: |
| Vehicle Condition | Auto Cancel Condition | Fail-safe Deactivation Condition |
| Cruise main indicator light goes off |
| Push the cruise control main switch to + RES |