CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - POWER MANAGEMENT CONTROL ECU) |
![]() |
Disconnect the power management control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L5-11 (TC) - L61-13 (TC) | Always | Below 1 Ω |
| *1 | DLC3 |
| *2 | Front view of wire harness connector (to Power Management Control ECU) |
Connect the power management control ECU connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TERMINAL CG of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L61-4 (CG) - Body ground | Always | Below 1 Ω |
| *1 | DLC3 |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L61-13 (TC) - Body ground | Always | 10 kΩ or higher |
| *1 | DLC3 |
|
| ||||
| OK | ||
| ||