Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR NO. 2 FLOOR BOARD


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    B226976E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw to remove the lower No. 3 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape



7. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    B226978E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw to remove the lower No. 2 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape



8. REMOVE STEERING PAD

CAUTION:
When storing the steering pad, keep the airbag deployment side facing upward.

  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B226980E01
  1. Using a screwdriver, push the torsional spring to disengage the 2 pins.
    Text in Illustration 
    *1
    Torsional Spring



    B232532E01
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector from the steering pad.

  1. Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the airbag connector to remove the steering pad.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.



9. REMOVE CRUISE CONTROL MAIN SWITCH


    E186306
  1. Disconnect the connector.



    E186305
  1. Remove the 2 screws and cruise control main switch.