Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM

PRE-CRASH SAFETY SYSTEM > PRECAUTION

for Preparation Click here



1.PRECAUTION FOR DISCONNECTING THE CABLE FROM THE NEGATIVE BATTERY

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected:


System
See Procedure
Intelligent Parking Assist System
Click here

2.TROUBLESHOOTING PRECAUTIONS
  1. If a terminal contact point malfunction or part installation problem occurs, removal and reinstallation of the suspected part may return the system to normal. However, be aware that the normal condition may only be temporary.

  2. Before disconnecting connectors or removing/installing parts, determine the malfunctioning area by checking and writing down the vehicle condition at the time of the malfunction (DTC outputs etc.).

  3. Be sure to check for DTCs related to other systems. The pre-crash safety system may be influenced by malfunctions in other systems.


3.HANDLING PRECAUTIONS
  1. When removing and installing the ECU, sensor, switch or other pre-crash safety system related parts, perform the following:

    1. Make sure the power switch is off unless otherwise specified in the inspection procedure.
    2. After the removal/installation, check for DTCs and confirm that a normal system code is output.