Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV RELAY ASSEMBLY

HV RELAY ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE UPPER HYBRID BATTERY COVER SUB-ASSEMBLY

HINT:
Click here.



2. DISCONNECT FRAME WIRE

CAUTION:
  1. Wear insulating gloves.
  2. Insulate the removed terminals with insulating tape.



    A215051
  1. Remove the 2 nuts, then disconnect the frame wire from the hybrid battery junction block assembly.

  1. Disconnect the clamp and frame wire.



3. REMOVE HYBRID BATTERY JUNCTION BLOCK

CAUTION:
Be sure to wear insulated gloves.

NOTICE:
Insulate the removed terminals with insulating tape.



    A215057
  1. Disconnect the 2 connectors from the hybrid battery junction block.



    A215058
  1. Disconnect the 2 connectors from the hybrid battery junction block.



    A215059
  1. Remove the 3 nuts and hybrid battery junction block.