BATTERY BLOWER > INSTALLATION |
| 1. INSTALL BATTERY COOLING BLOWER ASSEMBLY |
![]() |
Install the battery cooling blower assembly with the 2 bolts and nut.
Connect each battery cooling blower assembly connector and clamp.
![]() |
Connect the 3 wire harness clamps.
| 2. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT |
![]() |
Install the No. 1 hybrid battery intake duct with the 2 clips.
| 3. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH |
![]() |
Engage the 2 guides as shown in the illustration.
![]() |
Install the rear side seatback assembly RH with the bolt.
| 4. INSTALL REAR DOOR SCUFF PLATE RH |
| 5. INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT |
![]() |
Insert the No. 1 hybrid battery exhaust duct with the clip.
| 6. INSTALL REAR FLOOR BOARD SPACER |
![]() |
Install the rear floor board spacer with the 2 clips.
| 7. INSTALL REAR NO. 1 FLOOR BOARD |
![]() |
Engage the 2 claws and 2 clips.
Install the rear No. 1 floor board with the bolt.
| 8. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the claw and 2 clips to install the rear No. 2 floor board sub-assembly.
| 9. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY |
![]() |
Engage the 2 claws and 2 clips to install the rear No. 1 floor board sub-assembly.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY |
![]() |
Engage the 2 guides of the seat cushion to the seatback.
| *1 | 100 mm (3.94 in.) or less |
| *2 | Guide |
| *3 | Hook |
Engage the 2 front hooks of the seat cushion to the vehicle body.