Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT (w/ Filter)

BATTERY COOLING DUCT (w/ Filter) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER


    A308337E02
  1. Engage the 3 claws in the order shown in the illustration to install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.



2. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH


    B230046
  1. Engage the 2 guides as shown in the illustration.



    B230044
  1. Install the rear side seatback assembly RH with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



3. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side .



4. INSTALL REAR SEAT CUSHION ASSEMBLY


    B229993E01
  1. Engage the 2 guides of the seat cushion to the seatback.
    Text in Illustration 
    *1
    100 mm (3.94 in.) or less
    *2
    Guide
    *3
    Hook

  1. Engage the 2 front hooks of the seat cushion to the vehicle body.

    NOTICE:
    When installing the seat cushion, make sure that the seat belt buckle is not under the seat cushion.

    HINT:
    Confirm that the seat cushion is firmly installed.