Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT (w/ Filter)

BATTERY COOLING DUCT (w/ Filter) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B229992E01
  1. Disengage the 2 front hooks of the seat cushion from the vehicle body as shown in the illustration.
    Text in Illustration 
    *1
    100 mm (3.94 in.) or less
    *2
    Hook
    *3
    Guide

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the above procedure for the other hook.

  1. Disengage the 2 guides of the seat cushion from the seatback.

  1. Remove the rear seat cushion assembly.



2. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side .



3. REMOVE REAR SIDE SEAT BACK ASSEMBLY RH


    B230044
  1. Remove the bolt.



    B230045
  1. Disengage the 2 guides and remove the rear side seatback assembly RH as shown in the illustration.



4. REMOVE NO. 1 HYBRID BATTERY INTAKE FILTER


    A308337E01
  1. Disengage the 3 claws in the order shown in the illustration and remove the No. 1 hybrid battery intake filter from the No. 1 hybrid battery intake duct.